TREATS AND REMOVES:

COMPATIBILITY:

AR, Bolt Action Rifles, Revolver cylinders and barrels, Pistols and older fouled firearms.

Secure and unload the firearm.

1. Wet 3 patches with XTERMIN8R and push through the barrel. Run patches slowly through to give solvent time to react with the bore surface.
2. Run 15 passes through using a nylon brush soaked in XTERMIN8R. Do not use a brass brush.
3. Wet another 3 patches with XTERMIN8R, run through, then leave the product in the bore for 3-5 minutes. Extend the time for extreme fouling.
4. Do not leave the product in the firearm overnight.
5. Continuously run dry patches through until the patches gather no residue at the barrel tip.
6. Before storing your firearm dampen a patch with GT150 GUN OIL, run it through the bore as this will prevent rust and dust from settling on your firearm.
7. Always run a clean, dry patch through the firearm before use to prevent any obstructions.

This is the best all round bore cleaner in the industry. Twice as quick and removes more copper and carbon per patch than the competition.

• Blue copper indicator built in.
• Not for human or animal consumption.
• Always test the product on barrels and coatings before application.
• Keep out of reach of children.
• Store in a cool, dry place away from direct sunlight
• Acetone Free
• Ammonia Free
• Biodegradable

Q: Will the solvent damage my gun barrel?

A: This formulation will not damage the barrel of your rifle or sidearm and is considered barrel safe. XTERMIN8R has been tested on all types of barrels and is considered safe to use. XTERMIN8R is safe for Mild steel and Stainless steel barrels.  Stick to the given directions and avoid letting the solvent sit in the barrel for undisclosed lengths of time.

Q: How long can I leave this solvent in my barrel?

A: This formulation will not damage the barrel of your rifle or sidearm. Stick to the given directions and avoid letting the solvent sit in the barrel for undisclosed lentghs of time.

Q: Will this solvent damage my gun finish?

A: This formulation is not intended to be used on stocks and finishes. It is always wise to wipe of residual spillage on the stock or finish immediately after you witness the spill.

Q: I still see lines in my barrel after exposing my barrel to the solvent?

A: No chemical can be used as a miracle cure for cleaning the inside of the barrel. Make use of a proof positive copper brush or a nylon brush to ensure thorough cleaning. Also ensure that the barrel is not damaged, if so refer to your nearest gunsmith for assistance.